The control module is the central electronic component of the Razor Power Core E100. It manages the entire power delivery chain — receiving the signal from the thumb throttle, interpreting the rider's input, and directing current from the 24V battery pack to the hub motor in the rear wheel. Without a functioning control module, the scooter will not move regardless of battery charge level, throttle position, or motor condition.
When the control module fails on the Power Core E100, the symptoms are consistent and recognisable: the scooter refuses to move despite a fully charged battery and a functioning throttle, the power LED illuminates but the motor does not respond, or the scooter moves briefly before cutting out and requiring a reset. In all of these cases, the control module is the most likely cause — and this genuine replacement is the correct and complete solution.
This is the genuine factory replacement control module for the Razor Power Core E100 (Version 1 and above), featuring single speed control and a 7-connector wiring configuration matched exactly to the Power Core E100's wiring harness. It is a direct, plug-and-play replacement requiring no soldering, no re-wiring, and no modification to the scooter's existing wiring.
Exact 7-Connector Configuration — Direct Plug-and-Play Fit — The 7-connector wiring layout is the defining fitment specification for this module. It matches the Power Core E100's wiring harness connector positions exactly, ensuring a clean, direct connection without any re-pinning, adapting, or modification. Generic replacements frequently use different connector counts or layouts, requiring wiring modifications that introduce the risk of incorrect connections and further faults.
Hub Motor Compatibility — Calibrated for the Power Core Drivetrain — The Power Core E100 uses a hub motor integrated directly into the rear wheel — a fundamentally different drivetrain architecture from the chain-driven standard E100. This genuine module is calibrated specifically for the hub motor's electrical characteristics, ensuring correct current delivery, thermal management, and motor protection. A module calibrated for a chain-driven motor will not deliver the correct power profile to the hub motor and may cause premature motor wear.
24V Single Speed Control — Matched to the Power Core E100 System — The Power Core E100 operates at 24 volts with a single-speed control system — the thumb throttle delivers full power when engaged, with the module managing current delivery to protect the motor and battery. This genuine module is rated and calibrated for the 24V Power Core system. Fitting a module rated for a different voltage will result in incorrect operation and potential damage to the motor or battery.
Genuine Factory Fit — No Modifications Required — As a genuine manufacturer part, the module's mounting dimensions, connector positions, and wiring harness compatibility align exactly with the Power Core E100 chassis across all versions. No modification, re-wiring, or additional hardware is required.
Diagnose Before Replacing — Eliminate Other Causes First — The control module is the most commonly replaced electronic component on the Power Core E100, but it is important to eliminate other causes before fitting a new module. Check the battery charge level, test the throttle for correct operation, and inspect the wiring harness for damaged insulation or loose connectors before proceeding. This ensures the module replacement resolves the fault rather than masking a secondary issue.
Razor Power Core E100
Version 1 and above
Important — Power Core E100 vs. standard E100: The Razor Power Core E100 and the standard Razor E100 are different products with different drivetrain architectures, battery voltages, and control module specifications. This module (W13111243015) is designed exclusively for the Power Core E100 and is not compatible with the standard E100, E100 Glow, or any other E-series scooter.How to identify your model: The Power Core E100 has a hub motor integrated into the rear wheel — there is no visible chain or chain drive on the right side of the scooter. The standard E100 has a chain running from the motor to the rear wheel sprocket. If your scooter has a chain, this is not the correct module.How to identify your version: Locate the barcode sticker on the deck or underside of the scooter. The 7th and 8th digits of the product ID code indicate your version number (e.g., ""01"" = Version 1).
